BEKO DRVS DRCS Tumble Dryer DRUM DRIVE BELT 1967 9PHE 2953240200

Replacing the drive belt requires a bit of effort: Unplug the machine from the mains! Remove the top cover, (three screws at the rear of the lid and then slide back and lift up), remove the top tank pipes (push fit) and pipe clips taking note of which pipe goes where, remove all the screws from the rear case perimeter (not from the heater cover), remove, remove the rear bottom cover plate, unplug the mains internal cable from the mains suppressor and earth stud on the rear case, ease the rear case including the drum back about 1 inch and then unplug the heater connectors on the insider lower left (as seen from the rear), now remove the drum assembly and rear case. Remove the broken drive belt and slip the replacement over the drum. (Inspect the front felt drum seal and replace if need be.) Insert the drum assembly back into the machine ensuring the belt is not snagged. Reconnect the heater connectors and re-fix the rear case (beginning with the four corners). Check the belt is not trapped and is free to move. With a length of 15mm copper pipe carefully work the pipe on to the motor spindle whilst levering the belt into alignment. Initially it will seem like the belt is too short! Rotate the drum and the copper pipe and the belt will work its way down the pipe until it is over the spindle and then work the pipe off the spindle to leave the belt on the spindle. If needs be, push the belt whilst rotating the drum to get the belt position entirely on the running groves of the motor spindle. Then reconnect the internal mains cable to the suppressor and the earth stud, re-fix the motor cover plate, the top tank pipes (in the correct order) and the pipe clips. Refit the top cover. You should have no screws left over! Then plug the machine back in and give it a test. (I hope I haven't forgotten something in this guide! If in doubt call in a domestic appliance repair person!!)

Belt appears good quality and fitted a treat!

Does the job. You can ease on the very tight belt by levering it over the motor spigot with a 1/2 inch socket and extension bar. A smear of Vaseline over the socket helps too. Contrary to You Tube I found the best way to put on the new belt was just to remove the top panel, motor cover plate and back panel.

100% correct part for beko DRCS 68 condenser tumble drier. It's about a inch too short on comparison to broken slack belt, but apparently has to be. Very difficult to fit, but once done, using a crow bar in my case, it's perfect. Get help doing it, and good luck.

it was the right size

Worked well. Still going strong

This product is sold as Bri g suitable for Beko Dryer model DRCS 68 W which is what I purchased it for. However the product is shorter than the original beko drive belt and as a result dies not fit... This model of dryer needs to be removed from the item description!When trying to get a refund I was told I'd have to pay postage and packaging as I 9rdered the product incorrectly. Thus was not the case, the product was sold to me claiming to be comparable with my machine which it is not.

Like others I couldn't see this fitting, double checked numbers, measured against snapped one, how on earth I asked myself do I fit this!!! A two minute search on everyones best friend, YouTube, and a piece of steel pipe later and shazzam!!! All back up and running, with pants warm and cozy ready to wear straight out of the tumble..